Put a drop of pit filler resin on a mylar square and place the mylar over the point of impact. Alternatively put a drop of pit filler resin directly on the point of impact and cover it with a piece of mylar. For curing use a UV lamp with a power output of 4 W to10 W. After curing the surface of the pit filler resin can be finished with a razor blade and/or a polish to achieve best results. NOTE: The product should not get in contact with any rubber or plastic parts, nor painted surfaces of the vehicle. In case of contact rinse immediately with plenty of water or glass cleaner.

Highly viscous pit filler for a hard finish.

viscosity at 25°C: 300 mPa*s

shore hardness: D78

This is an extremely hard curing resin, creating a powerful bond to the glass surface. It is also easy to scrape off and then polish to perfection with our non-abrasive pit polish.

This grinding material is used for polishing the hardened UV resin surface. The polishing of the repaired stone chip improves glass transparency leaving a smooth surface.

PMA/TOOLS is not certified to ship hazardous goods by air freight.

Prep & Clean is a specially developed cleaner for stone chip repair. The spray is used for pre- and post-treatment of the damaged area as well as for cleaning of the repair instruments.

In the field of pre-treatment, Prep & Clean reliably removes finger prints, silicone remnants, dirt, humidity and small glass nano particles. As a result, the repair bridge is held safely on the glass surface. For optimal adhesion of repair resin to the repair spot, prepare the spot with Prep & Clean.

For post-treatment, Prep & Clean is used to clean all repair instruments. The fine spray pattern easily removes resin flakes, which occur when scraping off cured resin from the glass surface. Prep & Clean does not leave any smears and is therefore ideal for cleaning the windscreen after repair.

ATTENTION - DANGEROUS GOODS

This brush is an economical alternative to standard commercial brushes. Use this brush for problem areas such as corners etc.